LMT USA Inc. provides bar-peeling heads and inserts for new    bar-peeling machines as well as retrofit for older machines. Our     bar-peeling heads utilize quick-change cartridges and a central adjustment of tool holders, resulting in maximum flexibility and size adjustments. LMT USA's bar-peeling inserts are premium grade and use advanced grade coating technology to insure precision parts and maximum tool life.

Bar Peeling and Scaling

The processing of stock materials for the production of round steel and tubular products (loop production) is being increasingly done on bar peeling machines. The method is extremely cost efficient.
Advantages of Bar Peeling include:

• removal of burrs
• removal of decarbonizes surface layers
• removal of surface defects and fissures
• dimensional precision of blank surfaces

Indexable Inserts for Bar Peeling Operations without chip breaker.

• Especially for the processing of bar steel products with higher elasticity limits and high percentage of molybdenum and vanadium carbides
• For raw products with a poorer forging and rolling characteristics
• Bar Peeling of raw materials such as titanium, cobalt and nickel based alloys, heat resistant steels and mertensitic steel. Recommended setting angle æ=25¸.

Bar Peeling inserts are secured by means of an octagonal clamping plate made of hardened tool steel, which at the same time serves as a chip breaker and can be adjusted to compensate for progressive wear. It is also possible to mount two bar peeling inserts in one tool holder.

Indexable Inserts For Bar Peeling Operations With Chip Breaker.

• Optimum formation of chips
• Reduced power consumption
• For processing steels with low tensile strength
• For processing Cr-Ni steels

back to top